Programmers User Manual

124
13.62 Dome Mode Setting Verification Camera Control Command Type 1
Function Returns the dome mode setting value.
Command 00BDh
Length 2 byte Parameter
Value 01h
Length 2 byte Status
Range 00h~03h
Reference •Dome mode setting value
00h: Select cam path 0 to 9
01h: Select cam path 0 to 8
02h: Select cam path 0 to 7
03h: Select cam path 0 to 6
•Setting value of cam path 0 to 9
0: INF 1: 450cm 2: 201cm 3: 120cm 4: 80cm
5: 40.7cm 6: 9.2cm 7: 1cm
 Format of Control Code
d0 d1 d2 d3 d4 d5 d6 d7
Header Device Num Command Parameter End mark
FFh 30h 3Xh 00h BDh 30h 31h EFh
 Answer Format
 No Error
d0 d1 d2 d3 d4 d5 d6 d7
Header Device Num Error Code Status End mark
FEh 30h 3Xh 30h 30h s0 s1 EFh
⇓
Setting value indicates in 2 figures hexadecimal and returns ASCII code value
Noise Reduction s0 s1
Doom setting value : 00h ⇒ 30h 30h
Doom setting value : 01h ⇒ 30h 31h
Doom setting value : 02h ⇒ 30h 32h
Doom setting value : 03h ⇒ 30h 33h
 Generated Error
d0 d1 d2 d3 d4 d5
Header Device Num Error Code End mark
FEh 30h 3Xh e0 e1 EFh
⇓
Error Flag indicates in 2 figures hexadecimal and returns ASCII code value
Example: e0 e1
 In case of Parameter Error : 01010000B ⇒ 50h ⇒ 35h 30h
 In case of Mode Error : 10010000B ⇒ 90h ⇒ 39h 30h
 Conditions for setting of error flag
Parameter Error •In case of assigned parameter illegal
Mode Error •Not in status of Camera ON
•Not in status of Host Control Mode