Programmers User Manual

138
14.12 Remote Control ON System Control Command Type 1
Function To available remote controller.
Command 0080h
Length 1 byte Parameter
Value 0h
Status None
Reference •To set remote control ON by default during power ON.
•By issuing this command, forbidden flag of remote control in operation
status comes out zero.
•In case of host control mode, receive Key code from remote control even in
remote control ON, but not work remote control operation. Operation key
code can be confirmed by remote control through command ON. (see 9.
Function of Remote Control)
•In case of local control mode, to operate at key code in status of remote
control ON.
 Format of Control Code
d0 d1 d2 d3 d4 d5 d6
Header Device Num Command Parameter End mark
FFh 30h 3Xh 00h 80h 30h EFh
 Answer Format
d0 d1 d2 d3 d4 d5
Header Device Num Error Code End mark
FEh 30h 3Xh e0 e1 EFh
⇓
Error Flag indicates in 2 figures hexadecimal and returns ASCII code value.
Example: e0 e1
 In case of No Error : 00000000B ⇒ 00h ⇒ 30h 30h
 In case of Busy : 00010000B ⇒ 10h ⇒ 31h 30h
 In case of Parameter Error : 01010000B ⇒ 50h ⇒ 35h 30h
 In case of Mode Error : 10010000B ⇒ 90h ⇒ 39h 30h
 Condition of Error flag to be set
Busy •In case of executing Camera Control command.
•In case of executing Pedestal Control command.
•In case of executing Preset Move command.
Parameter Error •In case of assigned parameter illegal.
Mode Error •Not in status of Camera ON.
•Not in status of Host Control Mode.