Programmers User Manual

156
14.25 LED Normal Display System Control Command Type 1
Function To set LED lighting mode under the normal condition.
Command 008Eh
Length 1 byte Parameter
Value 0h
Status None
Reference •LED normal display comes out by default at the moment of power ON.
 Format of Control Code
d0 d1 d2 d3 d4 d5 d6
Header Device Num Command Parameter End mark
FFh 30h 3Xh 00h 8Eh 30h EFh
 Answer Format
d0 d1 d2 d3 d4 d5
Header Device Num Error Code End mark
FEh 30h 3Xh e0 e1 EFh
⇓
Error Flag indicates in 2 figures hexadecimal and returns ASCII code value.
Example: e0 e1
 In case of No Error : 00000000B ⇒ 00h ⇒ 30h 30h
 In case of Parameter Error : 01010000B ⇒ 50h ⇒ 35h 30h
 In case of Mode Error : 10010000B ⇒ 90h ⇒ 39h 30h
 Condition of Error flag to be set
Parameter Error •In case of assigned parameter illegal .
Mode Error •Not in status of Host Control Mode.
LED lighting Status in LED Normal Display Mode
LED Lighting Status Operating Status
Green ON Status in Camera ON
0.1 sec cycle Operating Remote Control buttons
0.5 sec cycle
Preset Memory Setting,
Preset Moving,
Menu Setting
Green blinking
1 sec cycle
Pedestal Initializing,
Camera Initializing
Orange ON Unmatched Remote Control ID
0.1 sec cycle Operating remote control with unmatched ID
Orange blinking
0.5 sec cycle Setting Remote control ID
Red ON In status of Camera OFF