Instruction Manual

Camera and Electronic Products for Integrators

Vaddio, 800-572-2011 Main, 763-971-4464 FAX, www.vaddio.com

Document 341-447 Rev B, Page, 1 of 2

Installation and User Guide

Ceiling Pendant Mount Kit

For DomeVIEW™ Indoor Pendant Mount Domes

Ceiling Mount Kit, Part Number: 998-9300-002

UNPACKING:

Carefully remove all of the parts from the packaging. Unpack and identify the following parts:

A) One (1) Ceiling Bracket

B) One (1) Mounting Flange with 1-½ ” NPT Adapter (2” tall)

C) Four (4) Pan-Head Screws, ¼”-20 x ½”

INSTALLATION:

1. Carefully unpack box, inspect contents for damage and verify that all components are included.

2. Remove the (4) ¼” - 20 screws (C) and set aside.

3. Mount the ceiling bracket (a) to ceiling using the appropriate fasteners (not supplied) for the mounting

surface. If using the ceiling bracket outdoors seal the holes in the back of the box from inside and

outside using a silicone chalk (with a 20yr rating).

4. If using conduit, attach ¾" conduit to the box. If conduit is outdoors, the conduit and connector must

be watertight. Route cabling into box and pull enough cable length to reach into the dome housing.

5. Replace the mounting flange (B). If using the ceiling mount outdoors, run a bead of the silicone

sealant to seal the box from moisture. Install the ¼” - 20 screws (C) and tighten firmly.

6. The mounting adapter fits 1-½” NPT pipe (not supplied). Install the 1-½” NPT pipe between the

mount and the pendant dome enclosure.

7. Refer to the housing instruction sheet to complete the installation.

SAVE THESE INSTRUCTIONS:

The information contained in this manual will help you install your Vaddio DomeVIEW product. If these instructions

are misplaced, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product

drawings for the Vaddio product line on the website. These documents can be downloaded from www.vaddio.com

free of charge.

Figure 2:

Exploded View - Components of the

Ceiling Pendant Mount Kit

Figure 1:

Ceiling Pendant Mount Kit with 1-½” NPT Pipe

Adapter Flange

Vaddio Part # 998-9300-002

 Dimensions (H x W x D):

5” (12.7cm) x 5” (12.7cm) x 2” (5.08cm)

Ⓐ

Ⓒ

Ⓑ

PAGE 1
Installation and User Guide Camera and Electronic Products for Integrators Ceiling Pendant Mount Kit For DomeVIEW™ Indoor Pendant Mount Domes Ceiling Mount Kit, Part Number: 998-9300-002 Ⓐ Ⓑ Figure 1: Ceiling Pendant Mount Kit with 1-½” NPT Pipe Adapter Flange Vaddio Part # 998-9300-002  Dimensions (H x W x D): 5” (12.7cm) x 5” (12.7cm) x 2” (5.08cm) Ⓒ Figure 2: Exploded View - Components of the Ceiling Pendant Mount Kit UNPACKING: Carefully remove all of the parts from the packaging.
PAGE 2
WARRANTY INFORMATION: Hardware* Warranty - One year limited warranty on all parts. Vaddio warrants this product against defects in materials and workmanship for a period of two years from the day of purchase if Vaddio receives notice of such defects during the warranty. They will, at its option, repair or replace products that prove to be defective.