User guide

CeilingVIEW SD CCU

Vaddio CeilingVIEW SD CCU Installation and User Guide - Document 341-769 Rev. A

Page 15 of 16

Appendix 3 (continued) Rear Panel Connections:

Power Supply Input:

36V 2.78 Amp power supply on a 5.5mm OD x 2.5mm ID connector.

RS-232 IN on RJ-45:

RS-232 Input from ProductionVIEW or other external RS-232 controller. NOTE: Daisy-chain control is not

supported with any of the CCU products.

RS-232 OUT / G/L Out on RJ-45:

RS-232 on Cat. 5 provide control to the CeilingVIEW Camera Module. NOTE: Genlock (G/L) is not

supported with CeilingVIEW CCU systems.

Tally on 2-pin Phoenix type connector:

Contact Closure lights LED on front panel allowing indication of which QCCU/camera combination is active in

a multi-camera/QCCU installation.

Unused Ports for the CeilingVIEW CCU Systems:

• Power - RJ-45

• G/L Input - BNC-F

• Camera Feature Switches: All of these switches should be in the down position.

• Y-Gain

• Distance

• Video Outputs

• Video RJ-45

Appendix 4:

Control Pin-outs for the Quick-Connect CCU

RS-232 IN Connector RJ-45

Signal - RS-232

1) Not Used

2) Not Used

3) Not Used

4) Not Used

5) Not Used

6) GND

7) RXD (from TXD)

8) TXD (to RXD)

RS-232 / G/L OUT Connector RJ-45