User guide

CeilingVIEW SD CCU
Vaddio CeilingVIEW SD CCU Installation and User Guide - Document 341-769 Rev. A
Page 6 of 16
Dip Switch Settings
Set the dipswitches to the desired signal/function and then apply power to the system. To make any
changes, remove power from the system, make the change and re-apply power to the system.
Description / Dip Switch 1 2 3 4 5 6
CeilingVIEW SD Laser Pointer “MOMENTARY ON” will be
activated by the Polycom or TANDBERG IR Remote
Controller “TILT DOWN” command
DN UP DN DN DN DN
CeilingVIEW SD Laser Pointer “MOMENTARY ON” will not
be activated by the Polycom or TANDBERG IR Remote
Controller “TILT DOWN” command
DN DN DN DN DN DN
Disable All Polycom and TANDBERG IR Remote
Commands
UP * * * * *
Figure 6: Vaddio IR Remote
Programming the Remote:
1. Install 3 “AAA” batteries into the remote
2. Press and hold POWER & MIRROR for 5 seconds
Function Description
POWER Camera on/off
ZOOM IN (tele)
OUT (wide)
FOCUS AUTO: Auto Focus Mode ON
NEAR: Manual Focus Near
FAR: Manual Focus Far
LASER ON: On/Off toggle
MOM: Turns on Laser for five seconds
BRIGHT UP: Brightness up
DOWN: Brightness down
PRESET Six (6) presets - 0 though 5
SET Sets Zoom Presets
W/BAL One Touch White Balance
BKLIGHT Back Light Compensation
B/W Black and White Mode (color off)
POS/NEG Positive/Negative - Art Mode
FREEZE Freeze Frame/Image Effect
Setting Zoom Presets (Vaddio Remote):
1. Zoom the camera lens to the desired position.
2. Press and hold the SET button for one second. The blue LED will blink for approximately 5 seconds.
3. Press button labeled 0 through 5 within the 5 seconds. The Blue LED on camera will stop blinking.
4. To Recall Presets, press on the PRESET buttons labeled 0 thru 5.