User guide

ClearVIEW HD-20

QDVI

YSTEM

ClearVIEW HD-20

QDVI

YSTEM

Document Number 342-0935 Rev A Page 11 of 23

Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket

After all cables are attached to the camera, place the camera onto the camera mount and insert the two 1/4”-20

screws into the camera through the two-screw slots in the bottom of the mount. Note: Be sure to align each side

of the camera evenly for the best fit prior to tightening the mounting screws.

Step 4: Install the CONCEAL Lower Cover Plate

Attach the CONCEAL lower cover plate. Slide the lower cover plate from front of the mounting bracket toward the

rear of the bracket. The two (2) rear locking tabs will need to be guided into position first and will lock in place as

the lower cover plate is pushed toward the rear of the mounting bracket. The two (2) front tabs will engage as the

cover is pushed back into place.

Step 5: Install the CONCEAL Rear Camera Cover

Install the CONCEAL rear camera cover on the mounting bracket with the supplied screw.

NOTE (One more time!): Verify that the Cat-5 cables are plugged in correctly. Plugging the

Power/Video cable into the wrong RJ-45 jack may cause damage to the camera system and

void the warranty.

Step 6: Connect System Power

Connect the 24 VDC power supply to the Quick-Connect DVI/HDMI-SR Interface and to an AC outlet. The SR will

power the camera via the Power/Video Cat-5 cable. The camera will “Home” to a centered position and will output

video when it has completely booted up. The ClearVIEW camera is now ready for control information from the

controller or IR Remote Commander.

A Note on Boot Order: When using a joystick controller or external control system, in order to

ensure proper continuity of control and operation of the cameras, the RS-232 controller should

be powered-on after the camera. In most, if not all cases, the camera needs to be on and

running in order for communication to take place between the camera and controller. When

plugging a new camera into a RS-232 controller/joystick that has already been powered up, a

system reboot or camera rescan may be necessary to find the camera.

CONCEAL Lower Cover Plate

with Locking Tabs

CONCEAL Lower Cover

Plate locked in place

CONCEAL Rear Camera Cover

Completed CONCEAL Wall Mount

Camera Bracket Installation