Manual

ControlVIEW XHD
ControlVIEW XHD Manual 341-917 Rev. C Page 11 of 24
Operating the ControlVIEW XHD:
Controlling the XHD
Functions and controls on the front panel are easy and intuitive. Over the next few pages there are
details on how the different functions operate, as well as how to program the inputs, outputs and trigger
devices connected to ControlVIEW XHD.
PTZ Camera Controls
The controls that can be used to
program presets, switch inputs,
adjust a PTZ camera can be
found on the Vaddio
ControlVIEW XHD IR remote
control supplied with the product
(see remote on p.6).
Preset Location Storage Options: This feature allows the user to store 72 First Step/Last Step camera
presets in the ControlVIEW XHD on up to six PTZ cameras. Any number of presets can be stored on any
number of cameras (i.e. 72 presets can be stored on one camera, 24 presets on three cameras, etc.).
Please see the ControlVIEW XHD Menu Structure, System Menu for access to the Preset location
parameter.
Before Programming Preset Camera Positions
Make note of all preset trigger devices connected to ControlVIEW XHD, and which presets will trigger
which devices. For instance, if there are four StepVIEW mats at the front of a lecture hall – two at
whiteboards, one at a podium and one at a document camera – note which presets each mat will trigger.
If there are additional trigger devices, such as microphones connected to Vaddio’s MicVIEW product,
then make a note of which presets these devices are connected to.
There are two ways to program presets into the ControlVIEW XHD; either by activating each trigger
installed in the system, or through the ControlVIEW XHD IR remote control. Knowing the preset
associated with each trigger will allow all programming to happen through the remote control. For this
manual, all preset programming described, will be handled through the IR remote control.
Setting First Step/Last Step Presets
1. Press the Program button on the front of ControlVIEW XHD
2. Confirm that either the First Step or Last Step button above Program is illuminated
3. Select the camera to program (Inputs 1 to 6) on the front panel of ControlVIEW XHD
4. Using the ControlVIEW XHD IR remote, pan, tilt and zoom the camera to the desired location for
the specific preset camera position. Example: If there is a StepVIEW mat (connected to Trigger
position 1 on the back of ControlVIEW XHD) at a whiteboard, frame the camera to capture the
area of the whiteboard visible above the StepVIEW mat.
5. Press 001 on the IR remote control. The LCD screen on the front of ControlVIEW XHD will
display “Preset 1 Stored”. The other way for storing the preset camera position would be to
manually trigger the device that will move the camera to that position. See note below about
numbering scheme for trigger presets.
6. Repeat the Steps 2 – 4 for each additional preset trigger device connected to the system.
NOTE: Please note that each preset trigger is three digits. Therefore, trigger 1 should be programmed
and recalled on the IR remote by pressing 001. Trigger 23 would be recalled by pressing 023 on the
remote.