User guide

ProductionVIEW HD
ProductionVIEW HD Manual 341-759 Rev. C Page 12 of 24
PIP Display
To set up and display a Picture-In-Picture
on the Program output, select the input that
will be the “background” on the Program
bus. Select the video input that will be the
picture-in-picture, or in the “window” on the
screen. In the example to the right, the
background is Input 1 on the Program bus
and Input 3 is the window on the Preview
bus.
Next, select the corner that the PIP window
will show up in, using the P.I.P. Positioning
buttons (upper left, upper right, lower left
and lower right). In the illustration to the
right, the lower left is selected.
To display the PIP, press either of the PIP buttons, and the PIP will appear on the screen. Input 3 will
now be displayed in a window in the lower left corner of the screen.
Changing PIP Size:
To change the size of the PIP (small, medium or large), press and hold the PIP
Positioning button and ProductionVIEW HD will toggle through the sizes.
PIP In Dual Mode:
If ProductionVIEW HD is set up for Dual Mode (independently switched live feeds on
Preview and Program buses), select the background source. Next, select the PIP source, which will
flash. Press the PIP button for that specific bus, and the window will be displayed. Press the PIP button
to remove the window from the screen. PIP is discrete for the Program and Preview buses when the
system is in Dual Mode.
Master Power, Manual and Auto Modes
If ProductionVIEW HD is to be used with an
operator at the console, the Manual mode button
will need to be illuminated.
Pressing the Auto button will activate the Auto
mode, which is a configuration when
ProductionVIEW HD is used in conjunction with
Vaddio’s StepVIEW mats, MicVIEW system and
AutoVIEW IR sensors or other trigger devices.
These triggers allow ProductionVIEW HD to
automatically switch between camera inputs and
preset camera positions. In this mode, no
operator is required.
The mats and sensors can be placed in locations, such as podiums, white boards, etc. to allow the
system to be run in “Presenter” or Auto mode. No operator needs to be present when the system is set
up in Auto mode. Camera switching and PTZ movements are handled by ProductionVIEW automatically.