User guide

ProductionVIEW HD
ProductionVIEW HD Manual 341-759 Rev. C Page 16 of 24
>Preset Location
>Local
>6 InCam 6 Local
In “Local” mode, the ProductionVIEW stores all 12 presets internally
In “6 InCam 6 Local” mode, the presets 1 through 6 will be stored in the cameras.
Presets 7 through 12 will be stored in the ProductionVIEW.
Note: The “6 InCam 6 Local” mode allows for switching video sources when cameras are moving
to preset locations. Since Presets are stored in Camera, the system does not have
to wait for position feedback before allowing another command to be entered.
>Switcher Mode
>Select
>Single Mode (Default)
>Dual Mode
NOTE: See page 2 for additional information on Dual Bus mode, as well as pages 9 – 12.
>Transition Swap (Default is On)
>On
>Off
>Settle Time (Default is 20)
>Select
>01 to 90
Note: Settle time allows the user to set up the time delay between pressing the Take button and
when the next button can be selected on the console. With a lower settle time, there is a
greater chance that a blue screen will appear on the Program output, when the video is
switched quickly, and repeatedly. In most applications this will not be an issue. In Single
Bus Mode, a faster Settle Time will also create a video roll on the Preview output, which
again in most situations will not be an issue.
>FTB Time (Default is 10)
>Select
>10 to 40
Note: FTB Time allows the user to set up a length of time that a fade to black on the Program
Output will occur. 10 is equal to 1.0 seconds, 11 is equal to 1.1 seconds, etc. FTB is
executed on ProductionVIEW HD by pressing and holding the Mix/FTB button for more
than 2 seconds.
>Program Lockout (Default is On)
>Select
>On
>Off
Note: Program Lockout prevents a user from selecting a different source on the Program bus of
the switcher. All switching of inputs must be accomplished by selecting an input on the
Preview bus, and then pressing the Take button.
>Save Config
>Save Config Now
Note: All changes are saved as they occur in the switcher. The Save Config allows the user to
save all parameter changes, if multiple changes have been made.
>Tally Level (Default is Active Low)
>Active High
>Active Low
>Select
Returns to Main Menu