Technical data

18 Installation and maintenance manual atmoCRAFT

4.7 Connection of the electrical cable

Fig. 4.19 Connecting the gas valves and the STL

• Connect the connection cable to the electronic box as

shown in the electrical schematic drawing, see 5.4.3

and 5.4.4.

4.8 Completing the boiler

Fig. 4.20 Fitting the back wall plate

• Hang the back wall plate (1) into the receptacle in the

side plates and secure it with one self-tapping screw

(2) on the left and right hand sides.

• Insert the braces (3) of the additional back wall plates

(4) and (5) into the back wall and screw both plates in

position.

Note!

Make sure that all the plates are securely

screwed together.

Fig. 4.21 Fitting the plinth adaptor

• Hang the plinth adaptor (1) into the lateral receptacles

in the side pieces.

Fig. 4.22 Placing the cover of the electronic box in position

• Push the cover over the electronic box so that it clicks

into place on the projection on the cross-beam.

4 Assembly