Operation Manual

Operating manual – auroMATIC 560 0020008427_0110
Operating modes:
Reheating function with timer program
Reheating function in constant standby
mode
No reheating
No actuation of solar pump(s),
no reheating
Reheating function in automatic mode – the
corresponding symbol for the time window
status is displayed next to the clock symbol.
Time window active
Reheating function in automatic mode
Time window not active
Display Required steps
Turn the dial, after 3 seconds the cursor
marks the temperature display, which
will be flashing.
Turn the dial to adjust the target value
for the cylinder temperature.
Click the dial - The cursor will mark the
operating modes. The selected operating
mode flashes.
Select an operating mode by turning the
dial.
Click the dial - The cursor will mark the
day of the week. The selected day of the
week flashes.
Turn the dial to select the current day of
the week.
Click the dial - The cursor will mark the
hours and/or the minutes.
Turn the dial to adjust the current time.
Table 5.2. Settings in the main operating level
5.5.3 Setting the reheating function timer program
You can create a timer program with up to three time
windows for reheating the solar cylinder.
The controller is equipped with a default program which
can be customised to meet your individual needs.
Time window Weekday/
Block of days
Start time End time
H 1 M0 - S0 5:30 22:00
H 2 — — —
H 3———
Table 5.3 Default reheating program
There are four steps to setting the times you want:
1. Select the time window,
2. Select a weekday or block of days,
3. Specify the start time,
4. Specify the end time.
You can specify up to three time windows, as long as
none of the time windows overlap another.
For clarification, the individual steps are shown in the
following table:
Display Required steps
Press the programming key P
Turn the dial until you see the tap sym-
bol.
Click the dial - The cursor marks the
changeable value (H1), which also flash-
es.
Select the time window by turning the
dial.
Settings: H 1, H 2, H 3
Click the dial - The cursor marks the
block of days display, which also flashes.
Select a block of days or a single day of
the week by turning the dial.
Settings: (MO-SU); (MO - FR); (SA-SU);
(MO); (TU); (WE); (TH); (FR); (SA); (SU)
Click the dial – The cursor marks the
start time and the hour display flashes.
Select the start time by turning the dial.
Click the dial again to set the minutes.
Click the dial – The cursor marks the end
time and the hour display flashes.
Select an end time by turning the dial.
To adjust the minutes, click the dial
again.
Table 5.4 Setting time windows
5 Operation