Operation Manual

5Installation instructions – auroMATIC 560 0020008427_01
a
Caution!
An optional electrical heating rod (EP) must be
installed with an additional relay or contactor
with a circuit-breaking capacity of at least
16 A. Never operate an electrical heating rod in
connection with the auroMATIC 560 without an
additional external relay or contactor.
Caution!
The C1/C2 contact is a 24 V low-voltage con-
tact and should never be used as a 230 V
switching contact.
5.1 Wiring according to hydraulic plan
To simplify installation, three hydraulic plans are stored
in the controller. The relevant plan must be selected ac-
cording to the system configuration used.
Each of the hydraulic plans show a possible system con-
figuration in which some system components are op-
tional.
a
Caution!
These hydraulic plans are only schematic rep-
resentations and cannot be used for the prepa-
ration of the hydraulic piping.
Hydraulic
plan
Bivalent cylin-
der
Monovalent
cylinder
Number of
collectors
Circulation
pump
connected
Solid-fuel boiler
connected
Integration of
second cylinder
or swimming
pool
1
X 1 yes no yes
X 1 no no yes
2 X 2 no no yes
3 X 1 no yes yes
Table 5.1 System configuration
Electrical installation 5