Operation Manual

Operating manual – auroMATIC 560 0020008427_018
5.4 Display types
5.4.1 Display, main operating level
The main operating level appears when the appliance is
switched on. Please refer to Sec. 5.5.2 for information
on how to set and change the values.
1
2
4
6
3
5
Fig. 5.3 Display, main operating level
Key
1 Display, solar yield present
2 Actual collector temperature
3 Actual time or LEG for anti-legionella function (if active);
FROS for frost protection function;
PROT for solar circuit protection function
4 Current day of the week
5 Current temperature of cylinder (the target temperature can
be called up and adjusted by turning the dial)
6 Current operating mode
5.4.2 Display, info level
You can access the info level by pressing the info but-
ton. The display initially appears as seen in the diagram
below. You can call up additional information by press-
ing the info button again (see Sec. 5.5.1). The informa-
tion called up appears on the display for roughly five
seconds, then the display returns to the main operating
level.
4
1
2
3
Fig. 5.4 Display, info level
Key
1 Info level
2 Display, solar yield
3 Yield in kWh
4 Set target temperature of cylinder
5.4.3 Display, programming level
You can access the level for programming the control-
ler‘s operating times by pressing the "P" programming
button. You can set timer programs here for reheating
the solar cylinder and for a connected circulation pump
(see Section 5.5.3 or 5.5.4).
The display returns to the main operating level if you
press the programming button.
4
5
6
7
1
2
3
Fig. 5.5 Display, programming level
Key
1 Programming level
2 Timer program for solar cylinder reheating
(water tap symbol) or circulation pump
(pump symbol)
3 End time
4 Start time
5 Day of the week or block of days
6 Cursor (marks the value to be changed)
7 Time window
5.4.4 Display, special functions
By pressing the "F" button, you can access the special
functions: party, one-time reheating, and holiday func-
tion. After roughly ten seconds, the selected function is
activated and the display returns to the main operating
level.
Please refer to Sec. 5.6 for information on how to acti-
vate the individual special functions.
1
2
3
Fig. 5.6 Display, special functions
Key
1 Special function activated
2 Cursor (marks the special function selected)
3 Symbol for the special function selected
5 Operation