Operating instructions

Additional functions
Operating instructions ecoTEC plus 0020116701_00 27
8
8.2 Displaying Live monitor (current status of
the boiler)
S.04
Heating mode
burner on
Back
8.3 Displaying Live monitor (current status of the boiler;
example)
Menu ¬ Live Monitor
This function allows you to read the current appliance sta-
tus of your boiler. In addition, the meaning of the message
is displayed as plain text.
The display is automatically updated if the appliance status
changes.
Status code Meaning
Displays in heating mode
S.00 Heating, no heat demand
S.02 Heating mode, Water pump running
S.03 Heating mode, Ignition sequence
S.04 Heating mode, Burner ignited
S.06 Heating mode, Fan overrun
S.07 Heating mode, Pump overrun
S.08 Heating, remaining cut-off time xx min
Displays in DHW mode (VUW boiler)
S.10 Hot water demand via fan sensor
S.14 DHW mode, Burner on
Displays in cylinder charging mode
S.20 DHW demand
S.22 DHW mode, Pump running
Special cases
S.31 No heat demand, summer operating mode
S.34 Heating mode, frost protection
S.40 Comfort safety mode active
8.1 Possible appliance statuses (selection)
8.3 Setting the display contrast
Back
Display contrast
20
8.4 Setting the display contrast
Menu ¬ Information ¬ Display contrast
Using this function, you can set the display contrast in rela-
tion to the brightness of the surroundings, to ensure that
the display is clearly legible.
8.4 Setting the language
Language
02 English
Cancel
Ok
8.5 Setting the language
Your approved competent person should have set the boiler
to your desired language. If you wish to set another lan-
guage, you can proceed as follows:
> Press and hold the right-hand selection button
and the plus button at the same
time.
> Also press the reset button briefly.
> Continue to press and hold the right-hand selection
button
and the plus button until
the display offers you the option to set the language.
> Use the minus button
or plus button
to select your desired language.
> Confirm the change by pressing the right-hand selection
button
("OK").
You must confirm the set language twice to ensure that you
have not accidentally set an incorrect language.