Installation Instructions
Installation
Installation instructions VRC 470f 0020124645_00 13
4
4.6 Fitting the controller
> Before mounting the controller on the wall, check
whether radio communication between the controller
and the radio receiver unit can be established (¬Sec-
tion8.7).
> If radio communication is adversely affected by elec-
trical equipment or buildings, then choose a different
installation site for the controller or the radio receiver
unit.
1
2
3
Fig.4.7 Fitting the wall-mounting base
1 Wall-mounting base
2 Mounting holes
3 Wall-mounting base finishing panel
Proceed as follows:
> Remove the wall-mounting base from the rear of the
controller by pulling the base downwards.
> Remove the finishing panel from the wall-mounting
base by pulling the top edge of the panel away from
the wall-mounting base with your fingers.
> Mark the position on the wall.
> Drill two holes of 6 mm diameter matching the posi-
tions of the fixing holes (2).
> Insert the wall plugs supplied.
> Fix the wall-mounting base (1) to the wall using the
screws supplied.
> Locate the two bottom lugs of the finishing panel (3)
in the holes in the wall-mounting base.
> Press the top edge of the finishing panel into the wall-
mounting base until it clicks into position.
Fig.4.8 Battery polarity
> Open the battery compartment on the underside of
the controller.
> Remove the two plastic strips between the batteries
and the contacts.
i
Make sure battery polarity is the right way
round (¬Fig.4.8).
Depending on usage, the batteries should last
approx. 1 to 1.5 years.
> Close the battery compartment.
> Hook the controller onto the wall-mounting base.
> Press the controller down onto the wall-mounting
base until it audibly clicks into position.
> Check the quality of radio communication (¬Sec-
tion8.7).