Installation Instructions

Operation
26 Installation instructions VRC 470f 0020124645_00
7
Selection
level 1
Selection
level 2
Selection
level 3
Setting level Values Unit Step size,
select
Factory
reset
Own setting
min. max.
Sensor/
actuator
test
Select module – – – Connected
expansion
modules
VR 61
2)
Actuator – LP/ZP, HK1-P,
HK2 AUF, HK2
ZU, HK2-P
Sensor VF2 VF2
VR 68
1)
Actuator – – – MA, KOL1-P,
LEG-P
Sensor KOL1, SP1, SP2,
Yield, TD1, TD2
actoSTOR
4)
Actuator – – – ZP, P1, P2, AL
Sensor T1, T2, T3, T4,
Anode
Installer
level
Screed
drying
function
HEATING 1 Day
6)
00 29 Day 1 00
Temperature
6)
Curr.
value
45 °C
HEATING 2 Day
2)
00 29 Day 1 00
Temperature Curr.
value
45 °C
Change
code
New code 000 999 1 000
Tab. 7.1 Overview of Installer level
1) Appears only if solar module VR 68/2 is connected.
2) Appears only if mixing module VR 61/2 is connected.
3) Appears only if mixing module VR 61/2 or solar module VR68/2 is
connected.
4) Appears only if cylinder actoSTOR VIH RL is connected.
5) Appears only if remote control unit VR 81/2 is connected.
6) Appears only if no mixing module VR 61/2 is connected.
7) This figure depends on which expansion module is connected. If no
expansion module is connected, the upper limit may be limited by
the setting on the boiler.
8) Appears only if solar station VMS is connected.
* If there is no fault, then the status is "OK". If there is a fault,
"Fault" appears here and you can read the error message (¬Sec-
tion10.2) here.