Installation Instructions

Installation 4
0020237057_00 Installation instructions 7
!
3. Carefully push the radio receiver unit into the wall base.
4.2 Installing the outside temperature sensor
4.2.1 Determining the installation site of the
outdoor temperature sensor
▶ Choose an installation site that generally meets the fol-
lowing requirements.
– not fully protected from wind
– not particularly draughty
– not in direct sunlight
– not affected by heat sources
– on a north or north-west facing façade
– in buildings with up to three floors, it should be loc-
ated two-thirds of the way up the façade
– in buildings with more than three floors, it should be
fitted between the second and third floor
4.2.2 Requirements for determining the reception
strength of the outdoor temperature sensor
– The set-up and installation of all system components
and the radio receiver unit (except for the control and the
outdoor temperature sensor) is complete.
– The power supply for the entire system is switched on.
– The system components are switched on.
– The individual installation assistants for the different sys-
tem components have been completed successfully.
4.2.3 Determining the reception strength of the
outdoor temperature sensor at the chosen
installation site
1. Observe all the points listed in "Requirements for de-
termining the reception strength of the outdoor temper-
ature sensor (→ Page 7)".
2. Read the operating concept and the operating example
described in the operating instructions for the control.
3. Stand next to the radio receiver unit.
A
B
!
4. Open the control's battery compartment as shown in the
figure.
5. Insert the batteries, making sure that the poles are the
right way round.
◁ The installation assistant starts.
6. Close the battery compartment.
7. Select the language.
8. Set the date.
9. Set the time.
◁ The installation assistant switches to the Control
signal strength function.
10. Take the control to the chosen installation site for the
outdoor temperature sensor.
11. Close all doors and windows behind you on the way to
the installation site for the outdoor temperature sensor.
12. If dashes (--) appear in the display instead of the value
and the background lighting is off, press one of the se-
lection buttons or turn the rotary knob.
Conditions: The background lighting is on, The display is showing dashes
(--)
▶ Make sure that the power supply is switched on.
Conditions: The background lighting is on, The display is showing dashes
(--), The reception strength is < 4
▶ Find an installation site for the outdoor temperature
sensor that is within the reception range.
▶ Find a new installation site for the radio receiver unit that
is closer to the outdoor temperature sensor and is within
the reception range.
Conditions: The background lighting is on, The reception strength is ≥ 4
▶ Mark the position on the wall where the reception
strength is sufficiently high.