Owner`s manual

ManualsBrandsVais Technology ManualsMusical equipmentSL2s

XM Radio controls

Presets

NOTE: Beep indicates successfully accomplished operation. If you do not hear a beep, please repeat the above steps.

Select the desired channel

Press the or button 4 times ( within 1-2 seconds) You will hear a beep.

SoundLinQ2 will store the current channel in the preset list. You can store up to 10 preset channels, and channels get

recorded in sequential order.

[RPT] [REPEAT] MUST BE DONE .

Adding a new PRESET

Select preset you would like to changethe (using the , buttons)

Select new desired channel (using the , buttons, or use irect entry on the Navigation screen

(if supported). Make sure you do not select channels which already exist in “Presets list”, because unit will move to

another preset.

Press the or button 4 times ( within 1-2 seconds) You will hear a beep.

SoundLinQ2 will update the preset list.

[][]

MUST BE DONE

DISC+ DISC-

TRACK+ TRACK-

[RPT] [REPEAT]

“D ”

Changing an existing PRESET

NOTE: Beep indicates successfully accomplished operation. If you do not hear a beep, please repeat the above steps.

Enter into “XM Radio Input Settings” Mode ( See “XM Radio Input Settings” for details)

Press the or button one time to activate the “DISC REPEAT” function.

Press the or button again to deactivate it.

SoundLinQ2 will produce a long beep as an confirmation of successful erasure.

Exit “XM Radio Input Settings” Mode ( See “XM Radio Input Settings” for details)

[DISC RPT] [DISC REPEAT]

Erasing PRESETS

Used to display “ ”Signal Strength

Note: Will range from 0-99

Satellite Signal Strength

Press the [ ] button 4 times ( within 1-2 seconds). You will hear a short beep.

SoundLinQ2 w ll display the signal strength in position where channel number is normally displayed

To cancel this mode simply press [TRACK+], [TRACK-].

SCAN MUST BE DONE

.NOTE: Use this mode to find the proper antenna location for best reception

XM Radio Input Settings

Press the [ ] button 8 times ( within 1-2 seconds) to enter “XM Radio Input Settings” Mode. You

will hear a short beep as a confirmation.

SoundLinQ2 will use the “REPEAT” indicator (continuous blinks 2 times per second) on your head unit to confirm “XM

Radio Input Settings” Mode is active.

Press the [ ] button 8 times ( within 1-2 seconds) to exit “XM Radio Input Settings” Mode.

You will hear a short beep as a confirmation.

SCAN

MUST BE DONE

Enter/Exit “XM Radio Input Settings” Mode

NOTE: In this mode you can setup Display Settings, Erase PRESETS list, and Adjust Sound Level for XM Radio Input