Owner`s manual

Installation

CD-MP3 Emulation Mode Selection (CD-MP3 emulation)

CD-MP3 Emulation Mode programming steps:

! Properly install this unit.

! Put “Left” programming switch in “DOWN” position.

! Put ignition switch into the “ACC” position.

! Wait for long beep followed by a few short beeps. This may take up to one minute.

! Return programming switches into their default position (both switches “UP”).

Wait up to 30 seconds until confirmation beep.

! Put ignition switch into the “OFF” position. Wait at least 10 seconds.

! Put ignition switch into “ACC” position.

! Check SoundLinQ2 for functionality, especially TEXT capabilities.

“Hard” Velcro Fastener

Carpet or car chassis

SoundLinQ2

“Soft” Velcro Fastener

Mounting unit using Velcro fasteners

! Velcro Fasteners are not included

! VAIS Technology strongly recomand to ground unit to the car chassis for best results

! Do not more the 5mm size screws. Using screws larger then 5mm may damage the PCB board.

NOTE

M4 x 5mm*

(see note below)

Ignition into

“ACC” or “ON”

position

Both

switches

“UP”

Ignition into

“OFF” position

up to 30 sec

Confirmation beep

Left

switch

“DOWN”