Owner manual

Chapter 5 __________________________________________ Software Configuration and Operation
VAISALA ______________________________________________________________________ 153
NOTE
Commands have to be typed in the same case as indicated in the help
texts, usually in lower case.
The command name and the following parameters are always separated
by a space. Pressing ENTER (return) will execute the command so that
the QML logger reads the typed command.
You can use BACKSPACE to delete the last typed character.
Use CTRL+P (hold down the CTRL key and press P) to repeat the
previously typed command. Use CTRL+P (Previous) and CTRL+N
(Next) to scroll through the list of previously typed commands. When
you find the command you would like to repeat, simply press ENTER.
File commands (dir, del, copy, move, verify) can be aborted with
CTRL+C.
Closing Service Connection
If your connection to the QML logger works via a modem, remember to
close the line after you finish working with the logger. To close the
connection, choose Disconnect from the File menu.
If your connection to the QML logger is direct, you are recommended to
close the service connection by entering the close command or selecting
Terminal Disconnect on the Maintenance menu. The program closes
the service connection automatically after 5 minutes.
Station Parameter Backup and Restore
AWS Client can be used to create a backup of station-specific settings
from the logger, and to restore a backup file to the logger.
To create a station settings backup with AWS Client, proceed as follows:
1. Establish connection to the data logger.
2. Open the Settings menu and choose Parameters and Backup
from Logger.