Owner manual

Chapter 6 ______________________________________________________________ Maintenance
VAISALA ______________________________________________________________________ 203
2. By default, the loader.exe application uses the COM1 port of the
computer. When you can use the COM1 port, proceed with step a.
below; otherwise, proceed as instructed in step b.
NOTE
If any other COM port of the computer than COM1 is used for loading
the software to AWS330, you need to make a .bat file for software
loading. Refer to step b.
a. Connect the maintenance cable to the port COM0 of the
AWS330 system and to the COM1 port on your computer.
b. Connect the maintenance terminal cable to the port COM0 of
the AWS330 system and to any free COM port on your
computer. For example, if the free COM port is COM3,
make the .bat file with Notepad, see Figure 120 below.
In the .bat file, the parameter -s115200 indicates the bit rate
(the default is 38400) and the parameter -pCOM3 indicates
the communication port (the default is COM1).
1101-028
Figure 120 Making .bat File in Notepad
3. Close any terminal connection to AWS330 so that the serial port is
free for software loading.
4. Close all other Windows programs.
5. To load the software, follow the instructions given in either step a.
or b.:
a. When you are using the COM1 port of your computer, open
Command Prompt and change the directory to the folder
where you have loader.exe and bin.mot. Type loader and
press ENTER. The Command Prompt window shows
Waiting.
b. When you are using some other communication port, execute
the .bat file created in step 2.b. The Command Prompt
window shows Waiting.
6. Reset the logger by pressing the reset button.
7. The Command Prompt window shows Erasing for some time
and then starts to show Loading. If you get a load error, try again
from step 2.