User`s guide

USER'S GUIDE____________________________________________________________________
66 __________________________________________________________________ M210855EN-D
Service Port Connection
Table 11 Fixed Communication Settings for Service Port
Parameter Value
Bit rate 19200
Parity No
Data bits 8
Stop bits 1
Flow control None
To create a service port connection:
1. Connect the serial interface cable (optional accessory) between
the serial port of your PC and the service port connector on the
motherboard.
2. Open a terminal program and set the communication settings
(see the following section for detailed instructions).
3. Power-up the barometer.
Terminal Program Settings
The instructions below describe how to connect to PTB330 using the
PuTTY terminal application for Windows. Perform the necessary
cabling and configuration of the transmitter before following the
instructions.
PuTTY is available for download at www.vaisala.com
.
NOTE
PuTTY cannot be used to access the transmitter through the User Port if
PTB330 is configured to use the MODBUS protocol. However, you can
always use PuTTY to access PTB330 through the Service Port.