Owner's manual
Table Of Contents
- DMT345/346 USER'S GUIDE
- TABLE OF CONTENTS
- GENERAL INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- OPERATION
- Getting Started
- Display/Keypad
- MI70 Link Program for Data Handling
- Serial Line Communication
- LAN Communication
- Communicating with a Transmitter in POLL Mode
- General Settings
- Serial Output Settings
- Data Recording
- Analog Output Settings
- Operation of Relays
- Sensor Functions
- MODBUS
- MAINTENANCE
- CALIBRATION AND ADJUSTMENT
- TECHNICAL DATA
- EXAMPLE INSTALLATION OF DMT346
- CALCULATION FORMULAS
- MODBUS REFERENCE
User's Guide _______________________________________________________________________
76 ___________________________________________________________________ M210762EN-G
Serial Line Communication
Connect the serial interface by using either the user port or the service
port.
For permanent interfacing to host system, use the user port. You can
change the serial settings and operate in RUN, STOP, POLL, and
MODBUS modes.
For temporary connections use the service port. Service port is always
available with fixed serial settings.
0605-039
Figure 48 Service Port Connector and User Port Terminal on the
Motherboard
The following numbers refer to Figure 48 above:
1
=
Service port connector
2
=
User Port Terminals