Owner's manual

Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 81
Using Display/Keypad
You can configure the IP settings of the LAN and WLAN interfaces
using the display/keypad as follows:
1. Press any of the arrow buttons to open the Main Menu.
2. Press the ► arrow button to select Interfaces.
3. Press ► arrow button to select Network settings. There will be a
delay as the transmitter refreshes the network information.
4. You are now in the Network Interface menu. Selecting the IP
configuration option opens the IP configuration menu.
1102-015
Figure 50 Network Interface Menu
The Network Interface menu also allows you to configure the
Communication Protocol, enable or disable the Web
configuration option, or Disconnect all users that are currently
accessing the LAN or WLAN interface.
5. In the IP configuration menu, select Automatic configuration
(DHCP), or enter the IP address, Netmask and Gateway
manually. If automatic configuration is enabled, manual
configuration cannot be done.
0709-004
Figure 51 IP Configuration Menu
To enter a value manually, use the ▲▼ arrow buttons to select the
parameter to change, and press Change. A cursor will appear in the
first digit. Move the cursor using the ◄► arrow buttons, and
change the value under the cursor using the ▲▼ arrow buttons.
Confirm the selection by pressing OK.
6. After configuring the desired parameters, press EXIT to apply the
changes and return to the basic display.