Owner's manual
Table Of Contents
- DMT345/346 USER'S GUIDE
- TABLE OF CONTENTS
- GENERAL INFORMATION
- PRODUCT OVERVIEW
- INSTALLATION
- OPERATION
- Getting Started
- Display/Keypad
- MI70 Link Program for Data Handling
- Serial Line Communication
- LAN Communication
- Communicating with a Transmitter in POLL Mode
- General Settings
- Serial Output Settings
- Data Recording
- Analog Output Settings
- Operation of Relays
- Sensor Functions
- MODBUS
- MAINTENANCE
- CALIBRATION AND ADJUSTMENT
- TECHNICAL DATA
- EXAMPLE INSTALLATION OF DMT346
- CALCULATION FORMULAS
- MODBUS REFERENCE
Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 93
Getting Measurement Message from
Serial Line
Starting Continuous Outputting
R
Enter the R command to start the continuous output of measurements.
Example:
>r
Tdf=-20.6 'C H2O= 958 ppmV x= 0.6 g/kg
>r
Tdf=-20.7 'C H2O= 958 ppmV T= 23.8 'C RH= 3.3 %RH
>
If a value is too long to fit to the allocated space in the output, or if there
is an error in outputting the quantity, the value is displayed with stars '*'.
You can change the format of the output with the following commands:
- Outputting interval can be changed with the INTV command.
- Output message format can be changed with the FORM command.
Stopping Continuous Outputting
S
Use the S command to end the RUN mode. After this command all other
commands can be used. You can also press the Esc button or reset the
transmitter to stop the outputting.
See command SMODE to change the default (power-up) operation
mode.