Manual

ManualsBrandsVaisala ManualsToolsGMP231

Vaisala CARBOCAP

Carbon Dioxide Probe GMP231

Installation

8-pin M12

connector

Support the

housing from the

two M4 screw

holes

Electronics

housing

Dimensions (in millimeters)

M12

54.4

163

118.5

Screw BN 10649 M4 x 8 mm

(for 1 mm thick sheet metal

attachment)

1121

Ø 30.2

1.3°

Ø 19

Ø 24.8

Reserve space

for M12 cable

Position only the filter

inside the heated chamber

Recommended diameter

for installation tube 44 mm

62.6

Insert the silicone plug

over the probe from

inside the chamber.

Cable

The electronics housing

should be in a ventilated

space that is open to

ambient air.

Equipment space

Insert the probe through the

chamber wall. The probe

and electronics housing

must remain outside the

heated chamber.

Chamber wall

Operating temperature

0...+70 °C (+32...158 °F)

Temperature durability

in standby mode

+195 °C (+383 °F)

Chamber interior

CARBOCAP

sensor

under PTFE  lter. The  lter

must be inside the chamber

completely.

Summary of content (2 pages)

PAGE 1
Vaisala CARBOCAP® Carbon Dioxide Probe GMP231 Installation Equipment space Chamber wall Chamber interior The electronics housing should be in a ventilated space that is open to ambient air. Insert the probe through the chamber wall. The probe and electronics housing must remain outside the heated chamber. Operating temperature 0...+70 °C (+32...
PAGE 2
Important - Read Before Installation GMP231 is designed to remain installed during typical heat sterilization cycles (maximum temperature inside chamber 195 °C / 383 °F). To achieve this, you must install and operate the probe correctly: • Only the sensor should be exposed to heat. The filter must be completely in the heated chamber, but the probe must remain inside the unheated chamber wall. The probe body must not extend more than 5 mm into the chamber.