Owner's manual

Chapter 4 ________________________________________________________________ Operation
VAISALA_______________________________________________________________________ 35
Formatting the Measurement Message
Formatting the Message
This command is used to change the serial output format of the commands
SEND and R.
FORM x <cr>
SAVE <cr>
x= format string
Format string consists of quantities and modifiers. You can select one or
more of the following quantities by keying in the abbreviation after
FORM command:
Table 4 Quantities
Abbreviations Quantities
CO2 Filtered CO
2
results. Factory setting.
CO2RAW Unfiltered CO
2
results.
CO2RAWUC Unfiltered CO
2
results. Compensations (P/T/RH/O
2
)
and corrections (MPC/LC) do not apply.
TIME Time passed from last reset
ADDR Transmitter address
ERR Error flag (0=no error/1=error) in POLL or RUN modes.
T Measured temperature
P User-set pressure value
RH User-set relative humidity value
O User-set oxygen value
Table 5 Modifiers
Abbreviations Explations
x.y length modifier (whole numbers and decimal places)
#t tabulator
#r carriage-return
#n line feed
"" string constant
U5 unit field and length