Owner's manual

Appendix B ________________________________________________________ List of Commands
VAISALA_______________________________________________________________________ 89
APPENDIX B
LIST OF COMMANDS
This appendix lists the serial commands of the GMP343.
Measurement Commands
The bold text in the brackets is a default setting. Key in the commands with
the keyboard of your computer and press enter. In this guide, <cr> stands
for pressing ENTER.
R Start the continuous output
S Stop the continuous output
ECHO Turn the serial interface echo ON/OFF
INTV Set the continuous output interval
SEND Output the reading once
SMODE Set the serial interface
SERI Serial line settings (default 19200 8 NONE) baud: 300 ... 115200
ADDR Set the device address
CLOSE Close the line to POLL mode
OPEN Open temporarily connection to the POLL-mode device
FORM Set the output format of SEND and R commands
RSMODE Set the output hardware to use either RS-232 or RS-485