Owner manual

Chapter 2 ___________________________________________________________ Product Overview
VAISALA ________________________________________________________________________ 17
1310-039
Figure 4 Transmitter Parts – Inside
1
=
Mounting base.
2
=
Opening for cable (wiring from top).
3
=
Terminal label.
4
=
Opening for cable (wiring from behind, recommended).
5
=
Label for RS-485 baud rate DIP switch settings.
Included only on digital models.
6
=
Orientation arrow – should point up after the mounting base has
been installed.
7
=
Screw terminals.
8
=
Place for zip tie (for cable strain relief)
9
=
Transmitter body.
10
=
RS-485 termination jumper (connects a 120 Ω resistor).
Included only on digital models.
11
=
GM10 module (measures CO
2
).
12
=
DIP switches for common configuration options. Digital models
have an extra DIP switch bank for transmitter address.
13
=
Grip for slide.
14
=
TM10 module (measures temperature only) or
HTM10 module (measures humidity and temperature).
15
=
HUMICAP
®
sensor (on models with humidity measurement).
2
3
4
6
8
7
14 15
1
9
13
10
11
5
12