Manual

User's Guide _______________________________________________________________________
38 ___________________________________________________________________ M210474EN-C
Measurement Output
Starting the Continuous Reading Output
Syntax: R <cr>
Starts output of measurements to the peripheral devices (RUN mode).
While the measurement output is active the only command that can be
given is S (stop).
The output mode can be changed with the FORM command.
Example:
>r
aw= 0.2000 aw T= 25.09 'C …
aw= 0.2000 aw T= 25.20 'C …
Stopping the Continuous Reading
Output
Syntax: S <cr>
Stops the continuous output. <ESC> can also be used to stop the output.
Set Continuous Output Interval for RUN
Mode
Syntax: INTV xxx yyy<cr>
Where
Xxx
=
Output interval (0 ... 255)
yyy
=
Unit (s, min or h)
Example:
>intv 1
Output interval: 1 S
>intv 1 min<cr>
Output interval: 1 MIN
>intv 1 h<cr>
Output interval: 1 H