User`s guide

Chapter 3 ________________________________________________________________ Operation
VAISALA______________________________________________________________________ 107
manually disable a measurement or a sensor. For detailed information,
see section Measurement Enable or Disable on page 107.
To see the logging groups, type logstatus. To see the current logging
status of a certain group, type logstatus <group_id>. To stop or start
logging of a certain group, type logstop/loggo <group_id>. For the
output of the commands, see Figure 90 on page 107.
0312-068
Figure 90 Output of the Logstatus Command
Measurement Enable or Disable
You can manually enable or disable all measurement inputs and
sensors. You can use this feature for example to:
- Change remotely the readings of a faulty sensor to be flagged as
invalid.
- Mark all sensor readings invalid during the maintenance operation.