User`s guide

User’s Guide ______________________________________________________________________
146 __________________________________________________________________M210662EN-A
3. Attach the heating element outlet to the printed circuit board. Put
the printed circuit board in place and fasten it with spacers (5).
4. Put the lower body assembly (4) carefully into place. Fasten the
three screws (3) at the bottom of the sensor. Make sure that the
bigger O-ring (14) is correctly positioned between the upper and
the lower sensor bodies. Check also that the connector O-ring (14)
is in place. The O-ring is recommended to be replaced with a new
one after each opening.
5. Tighten the hexagon nut of the connector (2).
6. Connect the cable plug to the sensor body connector. Fasten the
sensor body on the crossarm with three screws.
7. Mount the vane assembly onto the sensor body. Tighten the fixing
screw.
NOTE
When placing the lower body assembly, make sure that the O-ring is
correctly positioned between the upper and lower bodies. It is
recommended to replace the O-rings with new ones before
reassembling.