User`s guide

User’s Guide ______________________________________________________________________
96 ___________________________________________________________________M210662EN-A
Calibrating Sensors
For calibrating the sensors with MAWS Terminal, the Sensor
Calibration tab is available in the MAWS Stations Settings window,
see Figure 84 on page 96. The list of the MAWS sensors is displayed in
the tab.
0312-038
Figure 84 MAWS Station Settings Window: Sensor Calibration
Tab
NOTE
You must load an appropriate setup to MAWS, before you are able to
use the Sensor Calibration tab.
NOTE
The Sensor Calibration tab is not visible for the setups made with the
MAWS software versions prior to 3.06. With such an older setup,
MAWS common parameters frame shows only the calibration
values for the wind direction and solar radiation sensors, other sensors
need to be calibrated through the terminal connection with the
appropriate calibration commands.
CAUTION
When you upgrade a previous MAWS version to 3.06 or above, the
following sensors will not operate correctly in the Sensor Calibration
tab until they are removed from the setup and then re-created: CM6B,
CM11, QMS101, QMS102, and QMN101.