Manual

Chapter 3 _________________________________________________________ Retrofit Installation

VAISALA _______________________________________________________________________ 23

4. Attach the WMT700 sensor body to the WS425 mounting kit and

tighten the bolt.

5. Remove the transportation damper protecting the array and store it

for future use.

6. Connect the cable to the data acquisition system and power supply.

Connect the wires according to section Wiring on page 25.

WMT700 is now ready for operation.

1103-054

Figure 9 Tightening the Connector

The following number refers to Figure 9 above:

= Tighten the connector by rotating the ribbed part of the connector

by hand. DO NOT USE TOOLS.

NOTE

Verify that the connector is properly tightened to avoid water leakage and

damage to the sensor. If water leaks into the connector, this voids the

warranty for WMT700.