Manual

TECHNICAL REFERENCE___________________________________________________________
46 __________________________________________________________________ M211097EN-C
The WA command is executed by the ASOS at an interval that ranges
from 1 to 30 seconds. For the WA command, WMT700 responds to the
ASOS interrogation poll within 250 milliseconds of receiving the
request.
NOTE
The following WS425 F/G ASOS commands cannot be used with
WMT700: WB, WFIRMWARE, WJ, WD, WF, WR, WCAL, WH,
WT, WCDV, WSTK, WL, WM, WN, WSST, and WATE.
WMT700 can only be configured in the configuration mode. For a list of
configuration commands for WMT700, see Vaisala WINDCAP
®
Ultrasonic Wind Sensor Series WMT700 User's Guide.
WA — Fetch Averaged Wind Speed and Direction
This command requests the averaged wind speed and direction message
with peak winds.
WA <CR><LF>
The response to the WA command consists of the averaged wind speed
and direction data, peak wind speed, and associated direction. The
average wind speed is a scalar running average of the fundamental
1-second interval wind speed measurement made by WMT700. For a
description of the data message, see section WS425 F/G ASOS Data
Message on page 48.
You can set the wind averaging tim
e and gust time with the wndAvg and
wndGustTime parameters. Set the wndVector parameter to 0 to use
scalar averaging.
The command also fetches the WMT700 status, the averaging time for
average and peak wind speed and wind direction, and signal quality.
WS — Fetch Internal Diagnostics Information
This command requests the verbose Built-In Test (BIT) results.
WS<CR><LF>
The command gives a textual run down of the results of all Built-In Tests
(BITs). In every line, except the bad reading counter, the pass/fail