Installation guide

SV-EMS-220/221 Installation and Configuration

7-42 SkyView System Installation Guide - Revision R

1/8-27 NPT

5/8-18 UNF

Figure 37 - Rotax Oil Pressure P/N 456180 pinout

Both views are the sensor’s connector (not the cable connector).

Rotax Sensor Connector Pin

Rotax Connector Wire Color

SV-EMS-220 Connection

N/A (do not connect)

(Customer provided,

suggested color is Red)

Pin 15 (Red wire, can be

shared)

(Customer provided,

suggested color is White)

Pin 6 (White/Yellow wire)

Note: If you are converting a Dynon D10/D100 product installation to a SkyView installation,

you should remove any resistor that is connected to the existing oil pressure sensor. It is not

needed when used with SkyView.

Rotax oil pressure sensor P/N 956413 is only compatible with SV-EMS-220/221

D37 pin 6. It will not work with any other pin.

Oil Temperature Sensor

While a Dynon Avionics oil temperature sensor may be connected to any general purpose input

pin on the SV-EMS-220/221’s D37, we recommend that it be connected to pin 7 on this

connector.

The oil temperature sensor needs to be installed according to the directions of the engine

manufacturer. Dynon Avionics sells oil temperature sensors with both 5/8-18 UNF (Dynon P/N

100409-001) and 1/8-27 NPT (Dynon P/N 100409-000) threads. Ensure that you have the right

sensor for your engine.

Dynon P/N 100409-001 5/8-18 UNF Oil Temperature Sensor

is furnished with an AN900-10 Crush Washer (Dynon P/N

102189-000).

Figure 38–Dynon Avionics Oil

Temperature Sensors