Installation guide
   Autopilot Servo Installation, Configuration, and Calibration 
SkyView System Installation Guide - Revision R    10-21 
Figure 69–Top Bar SPD Indicator 
If the aircraft’s altitude rises above the target altitude bug and the autopilot cannot pitch the 
aircraft down without going above the maximum airspeed, SkyView presents the prompt:  
Figure 70 - Top Bar Airspeed High Indication 
The maximum airspeed parameter cannot be set to a value above 95% of Vne, which should be 
set to the specifications of your aircraft in the Airspeed Limitations Menu (reference page 5-7 
for more information) and is specified in the units set in the Measurement Units Menu (i.e., 
miles per hour, knots, or kilometers per hour; reference page 3-8 for more information 
regarding configuring the measurement units). As mentioned previously, the maximum value 
for this parameter is 95% of Vne. This is also the default value. 
To set the maximum airspeed: 
1.  Go to the Pitch Axis Maximum Airspeed Adjust Page (SETUP MENU > AUTOPILOT SETUP 
> PITCH AXIS > MAXIMUM AIRSPEED). 
2.  Adjust the maximum airspeed. 
3.  Press ACCEPT to save the value or press CANCEL to return to the Roll Axis Menu. 
Minimum Airspeed 
If the AP is engaged and the Minimum Airspeed limit is changed to a value that is 
higher than the current airspeed, the AP will immediately act to increase the 
airspeed to the new minimum airspeed setting. Dynon recommends that this setting 
only be adjusted with the AP disengaged. 
The pitch axis minimum airspeed is the lowest airspeed at which the pilot may engage the 
autopilot. The autopilot cannot be engaged at airspeeds below the minimum airspeed, with the 
exception of 0 knots, allowing for ground testing. 
When flying at airspeeds lower than the minimum airspeed or when the autopilot is engaged 
and the aircraft airspeed drops below the minimum, SkyView indicates that the aircraft has 
dropped below the parameter by displaying SPD indicators in the Top Bar as illustrated in Figure 
69 above. 
If the aircraft’s altitude drops below the target altitude bug and the autopilot cannot pitch the 
aircraft up without dropping below the minimum airspeed, SkyView presents the prompt: 
Figure 71 - Top Bar Airspeed Low Indication 










