Installation guide

SV-XPNDR-261/262 Installation, Configuration, and Testing
SkyView System Installation Guide - Revision R 11-21
To determine whether your transponder has an optional software update available for it, which
will require that it be labeled should you choose to update it:
1. Go to SETUP MENU > TRANSPONDER SETUP > (right click). If the STATUS line is yellow,
there is a software update available for the transponder.
2. Examine the STATUS line. Example:
ON LINE HW 22.03 FW 01.02 SW 02.02
The software version of the transponder follows the SW; in the example above the
software version is 2.02 (and thus, will be highlighted in yellow).
3. If STATUS is highlighted in yellow, and the version is earlier than 2.02, and you choose to
update the transponder, the new TSO authorization label must be applied concurrent
with updating the software. Go to
www.dynonavionics.com/transponder (PDF)
which provides a new TSO authorization label that you can print out, cut out, and apply
to the transponder.
4. Only after you have the label available, go to
SETUP MENU > TRANSPONDER SETUP > STATUS, press the LOAD button
and follow the instructions to update the software.
5. You must apply the new TSO authorization label before the transponder’s next use:
a. Cut out the label that is included in the printout from
www.dynonavionics.com/transponder (PDF).
b. Permanently affix the label to your physical SV-XPNDR-261/262 module. Do not
cover any existing labels.
c. Ensure that the method that you use to secure the label is durable. For example,
fully covering the label with transparent packing tape would satisfy this
requirement.