Installation guide

SV-COM-C25 Installation, Configuration, and Testing
SkyView System Installation Guide - Revision R 16-3
Physical Installation
SV-COM-PANEL – VERTICAL Installation Dimension Quick Overview
 Panel Cutout: (irregular – see drawing)
 Bezel Outline: 1.80” W x 3.532” T (45.72 mm W x 89.71 mm T)
 Note that the SV-COM-PANEL/V is sized such that two units can be stacked to
the same height as the height of an SV-D1000 display.
SV-COM-PANEL - HORIZONTAL Installation Dimension Quick Overview
 Panel Cutout: (irregular – see drawing)
 Bezel Outline: 3.532” W x 1.80” T (89.71 mm W x 45.72 mm T)
The figures on the following pages show recommended panel cutouts, mounting hole patterns,
and mechanical dimension for the SV-COM-PANEL/V (vertical) and SV-COM-PANEL/H
(horizontal). Use these diagrams to plan for the space required by the display.
To mount an SV-COM-PANEL, cut the opening in your panel, drill out the mounting holes, install
nutplates, and use the included mounting screws to fasten the display to the panel.
Your SV-COM-C25 is shipped with #6-32 hex-drive round head fasteners. Fasteners are 5/8”
long and require a 5/64” hex drive tool. Dynon recommends fastening the included mounting
screws to nut plates installed behind the panel. If access behind the panel allows, standard #6-
32 lock nuts or nuts with lock washers can be used. Do not rivet the SV-COM-PANEL to the panel
as this will hinder future removal if necessary.
The following installation procedure should be followed to install the SV-COM-425 remote
transceiver module, remembering to allow adequate space for installation of cables and
connectors.
 If you are installing two COM radios, it is acceptable to co-locate the two SV-COM-425
transceiver modules.
 Select a position in the aircraft for the SV-COM-425 that is not too close to any high external
heat source and where reasonable airflow is available. The SV-COM-425 is not a significant
heat source itself and does not need to be kept away from other devices for this reason.
 Avoid sharp bends and placing the cables too near to the aircraft control cables.
 Secure the SV-COM-425 to the aircraft via the four (4) mounting holes. The unit should be
mounted to a flat surface.
Additional items you will require for installation of SV-COM-C25, but which are not in the SV-
COM-C25 package, include:
 Nutplates for mounting SV-COM-PANEL to the panel
 Circuit breaker or fuse for power to SV-COM-425
 Power wires to SV-COM-425
 SV-COM-425 to SV-COM-PANEL wiring
 SkyView Network cables to connect the SV-COM-PANEL to SkyView Network