Installation guide

SV-COM-C25 Installation, Configuration, and Testing
16-18 SkyView System Installation Guide - Revision R
SkyView System Settings for SV-COM-C25
Network Setup
As with all other SkyView Network devices, the SV-COM-C25 must be configured into the
SkyView Network:
 Go to SETUP MENU > SYSTEM SETUP > NETWORK SETUP > CONFIGURE > (right click) >
DETECT (button).
 The SV-COM-C25 will be listed as SV-COM-PANEL.
 FINISH (button) > EXIT (button)
COM RADIO Setup
To adjust Squelch, Sidetone, and Microphone Gain, go to SETUP MENU > COM RADIO SETUP:
> SQUELCH LEVEL – Adjust squelch level so that the audio is heard during transmissions, and
muted when transmissions are not present.
> SIDETONE VOLUME – Adjust for your personal preference of how much microphone audio is
heard in the headset when transmitting.
> MIC GAIN – The default setting of 50 should work for most installations. If other people report
that your transmissions fade off at the end or can't be heard at all, you may need more mic
gain. If your transmissions are reported to sound "hollow", "robotic" or if they have a lot of
background noise, less mic gain is likely needed. Follow the instructions in this menu to find a
value that works for your installation. Also note these issues can only be heard on real
transmissions by third parties. The sidetone you hear in your own headset is completely
unaffected by Mic Gain.
Displayed COM (Top Bar)
The status of one COM radio can be displayed on the top bar. The radio that is selected here is
also the radio that you can send airports and frequencies to via SkyView’s Map Menu APT>COM
and TUNE COM buttons. See the SkyView Pilot’s User Guide for additional details.
 Go to SETUP MENU > SYSTEM SETUP > DISPLAYED COM and select which COM radio
status to display on the Top Bar (or NONE). (To display status of a non-Dynon Avionics
radio, a serial port connection must be installed FROM the radio TO the SkyView
display(s).
Post Installation Checks
 On ground
 Do all SV-COM-PANEL buttons and knobs function normally?
 Verify dim commands from SkyView display dim the backlighting of the SV-COM-
PANEL.