Installation guide

Appendix A: Maintenance and Troubleshooting
SkyView System Installation Guide - Revision R 20-5
INFORMATION). Note that the information in this menu may be useful during troubleshooting.
The information here cannot be edited on this screen; however, some parameters are editable
by the user on other screens.
This menu contains the following information:
 Display serial number
 Firmware version
 Display input voltage
 Backup battery charge state
 Operational state of the internal battery management circuitry
 Operational state of the internal voltage rails
 Screen brightness level
 Local light sensor output
 External light sensor output
 Brightness level output
 Contact input status
 Serial port status and current baud rate
 Button and joystick states
 Operational hours
Display Serial Number
The serial number of the display is noted here as SERIAL NUMBER: XXXXXX.
Display Firmware Version
The firmware version of the display is noted here as FIRMWARE VERSION: X.X.XX.XXX.
Display Input Voltage
The display's input voltage is list here as VOLTAGE: XX.XXV.
Backup Battery Module Charge State
If there is an SV-BAT-320 backup battery connected to the display, its voltage level is shown
here as BATTERY STATUS: XX.XXV. The battery is fully charged at 12.25V. Charging a completely
discharged battery may take up to 4 hours. To conserve your aircraft battery, the SV-BAT-320 is
only charged with SkyView detects your alternator/generator to be online.
Operational State of the Internal Battery Management Circuitry
The operational state of the display's internal battery management circuitry is listed here. If
there is an SV-BAT-320 backup battery connected to the display, you will see one of the
following states:
 CHARGING: SkyView system voltage is above 12.25V. SkyView is running on master power
and is charging the SV-BAT-320.