Installation guide

ManualsBrandsVAL Avionics ManualsMusical equipmentNAV 2000

361

362

363

364

365

366

367

368

369

370

Appendix C: Wiring and Electrical Connections

22-4 SkyView System Installation Guide - Revision R

USB Cable (from D37 connector)

The USB cable used in the SV-HARNESS-D37 is a unique part made to Dynon’s specifications

for this application and is not sold separately. Attempting to terminate a typical USB cable to a

DSUB connector causes the USB device to perform marginally (in our experience). For that

reason, we recommend that a homemade version of the Dynon SV-HARNESS-D37 to not

include a USB cable. Instead, purchase USB extension cables to plug into the two USB ports on

the back of the SkyView display.

SV-BAT-320 Connection

To connect a homemade harness to an SV-BAT-320, the following specifications must be

followed closely for the SV-BAT-320 to charge and work correctly:

Connector: Molex Micro-Fit P/N 43640-0301 (Digi-Key P/N WM1856-ND)

Pins: Molex Micro-Fit P/N 43031-0007 (Digi-Key P/N WM1841-ND)

Wire: 22 AWG Tefzel, NO MORE THAN 24” LONG; red w/yellow: M22759/16-22-24;

black: M22759/16-22-0

Function

SkyView D37

Connector Pin

Molex

Connector Pin

Power

Ground

Table 70 - SV-BAT-320 Wiring

OAT Connection

For customers that are converting from other Dynon products, you can use your installed OAT

with the addition of the connector below. Both 100433-000 and 100433-001 are compatible.

The OAT wiring can be extended as required. If you have 100433-001, ignore the red wire and

connect the yellow and blue wires to the connector below. The OAT is non-polarized; either

wire can connect to either pin.

Connector: Molex Micro-Fit P/N 43645-0200 (Digi-Key P/N WM1845-ND)

Pins: Molex Micro-Fit P/N 43030-0007 (Digi-Key P/N WM1837-ND)

Wire: 22 AWG Tefzel

SkyView Equipment Electrical Connections

A SkyView display (SV-D700 and SV-D1000) has six connectors on the back of the unit as

illustrated in Figure 122:

 One male D37 for connection to the SkyView Display Harness (SV-HARNESS-D37)

 Two male D9 SkyView network connectors

 Two Standard 4-pin USB 2.0 jacks for use with USB Series A plugs. Note that there is also a

USB port on the SV-HARNESS-D37 for convenience.