Installation guide

System Planning
2-16 SkyView System Installation Guide - Revision R
Dynon Part Number
Description
SV-NET-SERVO
SkyView Network Cabling Kit for Autopilot Servos
(includes 20 feet of wires, connectors, connector shells, crimp contacts,
insertion tool, heat shrink, and zip ties). One SV-NET-SERVO is used for
each servo in most installations.
SV-NET-TEST
SkyView Network Test Cable–Not Aircraft-Grade. One SV-NET-TEST is
shipped with each SkyView display. (10 foot)
SV-NET-HUB
SkyView Network Hub (5 SkyView Network connections)
Table 5–SkyView System Connection Hardware
Example SkyView Systems
SkyView systems are easily scalable and can accommodate a wide variety of components
ranging from a single display with one module to multiple displays with multiple modules. The
following diagrams illustrate several example SkyView systems and the components needed to
build them. Diagrams do not show a connection to aircraft power and do not imply an
installation location. Additionally, cable lengths and models pictured below should not be
blindly used as a “prescription”. Always consider your aircraft’s particular geometry and module
installation locations before purchasing harnesses, hubs, and splitters.
Figure 5–SkyView System with One Display and One ADAHRS
Figure 6–SkyView System with One Display, One EMS, One GPS, One Backup Battery, and Two Redundant
ADAHRS
SV-D1000
USB
Connector
SV-HARNESS-D37
SV-ADAHRS-200
SV-NET-10CP
(with installed D9)
KEY
DB9 Female
SV-D1000
USB
Connector
SV-BAT-320
SV-HARNESS-D37
SV-EMS-220
SV-NET-6CC
SV-ADAHRS-200
SV-ADAHRS-201
SV-NET-SPL
SV-GPS-250
GPS
Wire
Bundle
SV-NET-10CP
(with installed D9)
KEY
DB9 Male
DB9 Female