Installation guide

Basic SkyView Display Operation
SkyView System Installation Guide - Revision R 3-5
SkyView Touch
SV-D1000T displays can be controlled via touch in addition to using the conventional buttons
and joystick knobs. During normal usage, many of the on-screen elements can be touched to
control SkyView. Details about how touch is used in-flight are covered in the SkyView Pilot’s
User Guide. However, touch controls are not enabled in the SkyView Setup Menu and aren’t
generally used during installation and initial setup.
Menu Navigation
After the display turns on, you will see a screen similar to the one in Figure 10. This guide refers
to the label bar at the bottom of the screen as the Main Menu.
Throughout this guide, the “>” character is used to indicate a sequence of menu selections or
other actions you would take as you navigate the menu system. Menu selections which are
followed by “…” indicate full-screen wizard interfaces which guide you through the appropriate
steps. These wizard interfaces are not described in detail in this guide, as the on-screen
instructions provide adequate information.
SkyView menus follow this structure: SETUP MENU > MENU > ... > MENU > PAGE or WIZARD.
The setup menus (In Flight Setup or Setup) are the root of most menu navigation. Each nested
menu is more specific than the previous one and there is no set limit for the number of nested
menus before reaching a page. A page or wizard is at the end of the chain and it is where the
user can perform a specific action such as change a specific setting, configure a SkyView
network, or set up the layout of the onscreen engine gauges. Wizards employ easy-to-follow
onscreen instructions.
For example, SETUP MENU > SYSTEM SETUP > MEASUREMENT UNITS > BAROMETER indicates
entering the SETUP MENU, then selecting SYSTEM SETUP, then selecting MEASUREMENT
UNITS, and then entering the BAROMETER Menu to select INHG, MBAR, or MMHG.
Table 7 is a summary of menu navigation.
Desired Menu Action
User Action
Enter the Setup Menu
Simultaneously press and hold buttons 7 and 8
(if airspeed is greater than zero, you will enter the
In Flight Setup Menu)
Scroll through different menus
Turn either joystick
OR
Move either joystick up or down
Enter menu
Move either joystick toward the right
Return to previous menu
Move either joystick toward the left (saves settings)
OR
Press BACK (saves settings)
OR
Press CANCEL (does not save settings)
Save adjusted value
Press ACCEPT