Installation guide

Basic SkyView Display Operation

3-12 SkyView System Installation Guide - Revision R

 LICENSE – This page shows the status of software products that can be purchased and

licensed to add features to SkyView. This page is also the place where license codes can be

redeemed to activate features on your SkyView System.

PFD SETUP Menu

This menu contains links to the following pages:

 ADAHRS SOURCE SELECTION–This page has a list of all configured SkyView ADAHRS modules

and their respective status. Also use it to select which ADAHRS module is the PFD’s primary

source of data.

 FLIGHT ANGLE PITCH ADJUST – This page allows you to adjust the displayed pitch of the

plane.

 AIRSPEED LIMITATIONS – Enter this menu to configure the V-speeds and specify optimal

flight parameters such as best angle of climb speed, best rate of climb speed, and

maneuvering speed.

 VERTICAL SPEED SCALE – Enter this page to configure the vertical speed tape's scale.

 G METER – Enter this page to configure G values that will cause the G Meter to be

automatically displayed when exceeded; to set the yellow/red cautionary color ranges of

the G meter; and whether or not the max/min recorded Gs are reset at each SkyView boot-

up.

 FLIGHT PATH MARKER – Enter this page to enable/disable display of the flight path marker.

 EXTREME PITCH WARNING – Enter this page to enable/disable display of the extreme pitch

warning indicators.

 ANGLE OF ATTACK – Enter this page to enable/disable display of the Angle of Attack

indicator.

 ALTITUDE BUG ALERTER – Enter this page to configure the altitude alerter, an audible alert

when you are approaching or departing the altitude set in the ALT bug.

o CAPTURE BAND: When the altitude of the aircraft flies within this amount of

feet/meters of the altitude bug (when displayed), SkyView will announce

“approaching altitude” aurally (if audio output is configured)

o DEVIATION BAND: When the altitude of the aircraft climbs above or descends below

the altitude bug by the amount of feet or meters set here, SkyView will announce

“departing altitude” aurally (if audio output is configured).

 ALLOW SIX-PACK PANEL – Enter this page to enable / disable the option of displaying the

Six-Pack presentation flight data instead of EFIS presentation. If set to NO, the SIX-PACK and

EFIS buttons do not appear in PFD > MODE menu.