Installation guide

Basic SkyView Display Operation
3-14 SkyView System Installation Guide - Revision R
 Roll Axis–Enter this menu to configure autopilot roll axis setup and tuning parameters.
 Pitch Axis–Enter this menu to configure autopilot pitch axis setup and tuning parameters.
 Disengage Button–Enter this menu to configure disengage button options such as hold to
engage, enable broken line detect, and control wheel steering mode.
Transponder Setup Menu
This menu is not accessible unless a SV-XPNDR-261/262 is setup and configured.
Reference the SV-XPNDR-261/262 Installation, Configuration, and Testing Section of
this guide for more information.
This menu contains options that are used to set up and configure the SV-XPNDR-261/262
module. Reference the SV-XPNDR-261/262 Installation, Configuration, and Testing Section of
this guide for more information.
Hardware Calibration Menu
This menu contains links to the following menus:
 ADAHRS Calibration–Enter this menu to make altitude adjustments (e.g., baro and altitude
adjust) and access the compass and AOA calibration wizards.
 EMS Calibration–Enter this menu for EMS sensor calibration. You will have options to
calibrate fuel tanks and position potentiometers that have been mapped in the Sensor Input
Mapping Wizard. Calibration wizards contain onscreen instructions.
 Servo Calibration–Enter this menu for autopilot servo calibration. Reference the Autopilot
Servo Installation, Configuration, and Calibration Section of this guide for more details.
Note that if an ADAHRS, EMS, or Servos are not present on the SkyView network,
this menu will note the absence by displaying “(EMS NOT DETECTED)” ,“(ADAHRS
NOT DETECTED)”, or “(SERVOS NOT INSTALLED)”
Firmware Updates and File Operations
Dynon Avionics continually provides new functionality and capabilities to your SkyView system
via firmware updates. Use the resources mentioned in the Contact Information Section of this
document to stay current on firmware availability for SkyView.
Firmware updates and file operations are performed using a USB flash drive. A flash drive with
at least 50 Megabytes of storage is required for standard firmware updates. A drive with at
least 4 Gigabytes of storage capacity is required for terrain file updates. Note that a 4 Gigabyte
USB flash drive is included with every SkyView display, and is the recommended USB flash drive
for these operations.
In order to open the System Software Menu, you must have a USB flash drive plugged in to your
SkyView display.