Installation guide

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-18 SkyView System Installation Guide - Revision R
 *A108.00 Rs I:xxx (the *x*'s are a placeholder for the resolver setting)
o Rotate the left inner (small) encoder to show *Non* in the section following *Rs I:
o Push and hold both encoder buttons to exit from the configuration pages
On SkyView
 SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > VAL AVIONICS NAV 2000. This will automatically set the SERIAL IN/OUT BAUD
RATE and SERIAL OUT DEVICE.
 Set SERIAL IN FUNCTION TO NAV 1, 2, 3, or 4. If the NAV 2000 is the only NAV device, select
NAV 1.
 Set NAVIGATION SOURCE DISPLAY NAME: (user selectable, 7 characters – suggest
NAV2000). The name entered here is displayed as the HSI source and the Flight Plan Source
(if this device outputs a flight plan).
 SETUP MENU > SYSTEM SETUP > DISPLAYED COM: NONE (If a SkyView compatible COM
radio such as the SV-COM-C25 is installed, refer to those instructions for this setting).
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: NO (If a SkyView compatible
COM radio such as the SV-COM-C25 is installed, refer to those instructions for this setting).
Garmin SL40 COM Radio
SkyView can display COM radio information from the SL40 on the SkyView top bar and send
COM frequencies to the SL40 (TUNE COM).
 Connect SL40 serial RX pin 10 (RxD1) to a SkyView serial TX. If you have more than one
SkyView display, make the same connection to all SkyView displays.
 Connect SL40 serial TX pin 3 (TxD1) to one of the SkyView serial RX pins on each display. If
you have more than one SkyView display, make the same connection to all SkyView
displays.
 Ensure there is a shared ground between the SkyView display, and the SL40. If you have
more than one SkyView display, make the same connection to all SkyView displays.
 Configure the serial port on the SL40 appropriately.
 Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP > SERIAL IN DEVICE > GARMIN / APOLLO SL40. This will automatically set the
SERIAL IN FUNCTION, SERIAL IN/OUT BAUD RATE, and SERIAL OUT DEVICE.
 Set the SL40 status to be displayed on the top bar: SETUP > SYSTEM SETUP > DISPLAYED
COM > GARMIN / APOLLO SL40 (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES
Trig TY91 COM Radio
SkyView can display COM radio information from the TY91 on the top bar of the SkyView
display(s) and “push” COM frequencies to the TY91 (TUNE COM).
 Connect TY91 RS232 In (TC90 Pin 6) to a SkyView serial TX. If you have more than one
SkyView display, make the same connection to all SkyView displays.