Installation guide

viii SkyView System Installation Guide - Revision R
Revision
Revision Date
Description
L
July 2012
Clarified obtaining HEX CODEs for mode S operation.
Added SV-NET-HUB drawing with dimensions.
Location of pulses/gallon setting changed in setup menu.
Added dual SV-GPS-250 + dual display example connection diagram.
Clarified VP-X flaps and trim calibration procedures.
Added Dynon Capacitance to Voltage Converter current draw information for power
planning.
Clarified that audio output from ALL SkyView displays must be connected to audio
panels/intercom for proper audio operation.
Clarified % power only available on Lycoming / Continental engines.
Added crush washer spec for 100409-001 oil temp sensor.
Updated pitot/static test instructions.
Added metric units to most dimensions and weights.
Explained presence of unused 1.21K resistor in transponder connector kit.
Clarified fuel flow sensor placement recommendations.
Changed max SkyView displays supported to three.
Added instructions for using already-installed Dynon D10/D100 Series OAT Probes
with SkyView.
Added Rotax 912 iS information.
Added SkyView Network redundancy information to SkyView Network and
Troubleshooting sections.
Expanded ADAHRS Source Selection section with new cross-checking features.
M
December 2012
Updated SV-XPNDR-261/262 Installation, Configuration, and Testing chapter, as well
as relevant appendix data, to reflect updated ADS-B Out capability, improved squat-
switchless air/ground detection and automatic mode switching.
Added basic explanation of EMS voltmeter inputs.
Clarified the boom mount does not incorporate drainage features.
Added link to FAA AIM for further ADS-B and TIS system information.
Clarified SV-XPNDR-261/262 serial port wiring.
Added engine alert inhibit information.
Added voltage measurement capability and ultimate limit for type “C” EMS inputs.
Improved standby network error troubleshooting explanation.
Updated recommendation to have servos powered whenever SkyView is powered on.
Added description of take-off position marking for trim calibrations.
Added SV-ADSB-470 installation information.
Documented move of INHIBIT ENGINE ALERTS AT BOOT option to Engine Information
menu.
Updated return to service appendix.
N
January 2013
Updated Serial Data Output Format Specifications. SYSTEM and EMS formats have
changed for 5.1.
Documented new internal data logging feature. See appendix F.
Added a note to reinforce that the servo shear screw should NEVER be removed or