Installation guide

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-20 SkyView System Installation Guide - Revision R
 On the V6/V10, configure the serial port appropriately (per MGL Avionics’ documentation).
On SkyView
 SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > MGL V6/V10. This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT
BAUD RATE, and SERIAL OUT DEVICE. (Although there is no V6/V10 serial TX to SkyView
serial RX connection, SERIAL IN DEVICE must be configured as described.)
 SETUP MENU > SYSTEM SETUP > PRIMARY COM > MGL V6/V10 (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR > NO
f.u.n.k.e. Avionics ATR833 8.33 kHz-capable COM Radio
Garmin GTR 225 and Garmin GNC 255 8.33 kHz-capable COM Radio
Trig Avionics TY91 and TY92 8.33 kHz-capable COM Radio
11
Support for these radios was added in SkyView v11.0 – no earlier versions of SkyView firmware
support these radios in 8.33 kHz mode. SkyView can display COM radio information from the
ATR833, GTR 225 / GNC 255, and TY91/TY92 on the SkyView top bar and send COM frequencies
to the them (TUNE COM).
 Connect the radio’s serial RX to a SkyView serial TX. If you have more than one SkyView
display, make the same connection to all SkyView displays.
 Connect the radio’s serial TX to one of the SkyView serial RX pins on each display. If you
have more than one SkyView display, make the same connection to all SkyView displays.
 Ensure there is a shared ground between the SkyView display, and the radio. If you have
more than one SkyView display, make the same connection to all SkyView displays.
 Configure the serial port on the radio appropriately.
 Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP > SERIAL IN DEVICE >
FUNKE ATR833 or
GARMIN GNC 255 A/B or
GARMIN GTR 225 A/B or
TRIG TY9X 25KHz ONLY
TRIG TY9X 8.33/25KHz
This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT BAUD RATE, and
SERIAL OUT DEVICE.
Set the radio status to be displayed on the top bar: SETUP > SYSTEM SETUP > DISPLAYED COM >
(device you chose above) (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES
11
Full TY91/92 8.33 kHz support depends on a future software update from Trig.